Parts:

Ant1tuned 2.5" Down Pipes

Ant1tuned Exhaust

Ant1tuned Rear Seat Brackets

Ant1tuned Instrument Cluster EL Backround w/ Full LED's

Stainless Steel DOT Brake Lines

Pace Setter Headers

K&N Intake

Hypertech Power Module

Custom 8" Lift Leaf Springs

Custom Skyjacker 8" Lift Coils w/ towing leaf(not add a leaf)

Sky Jacker Camber/Caster Ball Joint Sleeve

2" Lift Blocks

2" Daystar Polyurethane Coil Spacer

Doetsch Tech Shocks

OMF Bead Locks on American Eagle 15" Wheels

Iron Bull Front Bumper

Corbeau CR1 Reclining Front Seats

Corbeau Rear Bucket Seats

Blaupunkt Hamburg MP5 w/ Bluetooth and Remote Microphone

Boss 4000 Watt Peak (2750 RMS) Amp

2 Diamond 15" Subs

1000 CA Rear Battery

220 AMP Alternator

Sony Xplode 6.5" Front

Sony Xplode 6x9" Rear

Viper 5902V Car Alarm

Cobra XRS 9730 Radar/Laser Detector

2" Diameter 120 Wall Full Roll Cage

Twin Turbo 351W
Rebuild 351W:

Forged connecting rods
Forged dished pistons (lower compression ratio)
Accel Fuel Rails with Adjustable Fuel Pressure Regulator
Make Oil Supply line for turbos
Modify Intake Manifold for direct injection nitrous
Fabricate Throttle Body Spacer for Water/Methanol Injection(Dont want to use higher octane fuel)
Fabricate Downpipes with Individual Thermocouples for EGT Gauges
Remove A/C Compressor and Replace with Idler Pulley

Modify Engine Compartment:
Remove Climate Control Box
Fabricate and Re-weld New Core Support with 3" for Inter-cooler Plumbing
Cut holes in front bumper for Dual  Inter-coolers
Relocate Battery for Water/Methanol Injection

Drive-train:
Convert Rear Drive-shaft to 1550 U Joints

Other:
Install 2nd Fuel Pump In Parallel
Exhaust Cut-Outs
Install A-Pillar Gages; Boost Gauge, 2 EGT Gages
Install Dash Expansion Panel for Gauges; Inter-cooler Temp Gauges, Transmission Fluid Temp Gauge, Oil Temp Gauge

Parts:

T3/T4 Turbos w/ Internal Waste Gate

Apexia Electronic Boost Controller

Autometer Gauge